CB2410 & CB2420 Wireless ColorBlast Controls
Now you can go wireless with your ColorBlast 6 and 12 fixtures. The CB24XX is a self contained battery pack and wireless receiver in one portable package and can be easily integrated into your current inventory of ColorMaker LED fixtures.

The CB2410 is compatible with all ColorMaker line of controls including DMX, Handheld and PC based systems. All the technology found in our controls including ColorRoll can be used to control the ColorBlast fixtures. Fixture data and power are connected to the CB24XX through a 4 pin XLR connector.

ColorBlast fixture can be mounted directly to battery pack for easy setup. The ColorBlast fixtures addressing is all done through the CB24XX so no special programming adapters are needed for compatibility.

The CB24XX internal batteries can be recharged with a 12 volt charger. There is no need for expensive hard to find 24 volt charging systems.
Fixture can be mounted directly to battery enclosure
Fixtures Data and Power
Fixtures power and data connect to the CB24 through a 4 pin XLR connector.

Auto Addressing
The CB24 auto address feature enable users to set the communication channel with a push of a button.
Specifications
CB2410
CB2420
Capacity 5 amp 24 volts 10 amp 24 volts
width 9.6 inch 17.8 inch
Height 5.0 inch 5.0 inch
Weight 10 lb. 18 lb.
Run time ColorBlast 6 4 hours (default mode) full RGB 8 hours (default mode) full RGB
Run time ColorBlast 12 2 hours (default mode) full RGB 4 hours (default mode) full RGB
4 PIN XLR Connection
 Output data specifications
  • Output baud rate: 250 Kilobits per second
  • Output signal 24V: +17 Volt signal
  • Output connector: Neutrik D-1 series

  • Pin 1 24VDC
  • Pin 2 Data +
  • Pin 3 Data +
  • Pin 4 Common (GND)
CB2410 with ColorBlast 6
CB2420 with ColorBlast 12