D1210 Power pack contains two 5Ah SLA batteries all the power needed to run the PS250 LED fixture for up to 8 hours on a single charge. TheD1210 can be recharged in a few hour and be ready for your next event. Durable aluminum enclosure protects the batteries along with in line power fuse. Quick connects on outside of enclosure for Charging batteries and Fixture power along with On / Off switch.
PCON1-12
12 inch cable to connect D1210 to Fixture
PCON1-120
120 inch cable to connect D1210 to Fixture
Quick connect hardware
Hardware used to connect the fixture to the D1210. No tools requires. Key holes in fixture bracket allows fixture to be detached from D1210 without removing hardware.
The D1210 Battery pack can be used to power several models of ColorMaker series LED fixtures Fixture run time is calculated when fixture is at full intensity. Below is a quick reference table for each model of fixture.
|
Fixture Run Time table at Full Intensity
|
|
|
Fixture
|
Run Time
|
|
PS250
|
7.5 Hours
|
|
PS500
|
3 Hours
|
Fixtures can also be calculated using formula below when fixtures will not be at full intensity.
10 / (.180 * % Blue) + (.180 * % Green) + (.180 * % Red)
What does it mean?
The D1210 is rated at 10 Amps Per Hour. Each Color on the DCR-54 will use 180 Ma or .180 Amps at full intensity. Use the Dimmer % to calculate the current that each color will use.
Example
DCR-54 is set to the Following. The % reading can be calculated using the CM-T10-PRO digital Display.
Red = 100 % - Green = 60 % - Blue = 20 %
Equation
10 / (.180 * 1.00) + (.180* .60) + (.180* .20)
10 / .180 +.108 +.036
10 / .324
30.8 Hours Run Time. The current draw at this setting is 324 Ma or .324 Amps.
This same equation can be used for PS250 and PS500 fixtures just substitute the Current for each Color using the table below.
|
Current required For each Color
|
|
|
PS250
|
330 Ma
|
|
PS500
|
566 Ma
|
Note: Equations are estimated run time and can vary depending on battery efficiency and age. Calculation are also based on battery at full charge and runtime ending when battery is at 10% charged. When battery reaches 20% charged there will be a small voltage drop in the battery which will decrease the intensity of the LED fixture.
|
Battery Charge Time Table
|
|
|
Charger
|
Charge Time
|
|
BT125
|
8 Hours
|
|
BT10 Bank (2.0 A)
|
5 Hours
|
Battery Tender is the most advanced battery charger on the market. Automatically switches from charge to Float to maintain charge level at full.
Volts output: 12 VDC
Maximum Load: 3 AMPS
Charge Cycles: 37
Weight: 10 Lbs
Width 9.6 inches
Height: 3.8 inches
Depth: 5.0 inches (without handle)
